High Tensile Galvanized Metal Wire | Mesh Weaving Diameter and Corrosion Inspection Selection
Générer un code QR
Product description
-
CoatingZ30~Z40HardnessMid Hard
-
Spangle TypeZero SpangleThickness0.12 ~ 0.2
-
TypeSteel CoilApplicationMaking Pipes, Cutting Sheets, Making Small Tools, Making Corrugated Sheets, Making Container
-
CertificateAPI , ISO 9001Delivery Timewithin 7 days
-
Gradeq235Oiled or Non-oiledNon-oiled
-
Processing ServiceWeldingSkin PassYes
-
StandardASTMTechniqueHot Rolled Based
-
Tolerance±1%Surface TreatmentElectro Galvanized
-
StatusSoft StateStrength of Extension300-1550MPa
-
Manner of PackingWoven BagTransport PackageSea Transportation
-
Wide in Width0.35mm-6.0mmMetal Wire DrawingCold Drawing
-
Zinc Coating8g-300G/M2
High Tensile Galvanized Metal Wire | Mesh Weaving Diameter and Corrosion Inspection Selection
Galvanized metal wire is identified by the title for mesh weaving, with high-tensile and anti-rust requirements. Define the intended wire diameter and coating before selecting the weaving configuration.
The sheet-coil identity and wide options retained below are not incorporated into the wire description. Request the steel chemistry, dimensional tolerance, required tensile acceptance and zinc-coating record for the supplied batch. An anti-rust phrase does not provide a tested service interval, and high-tensile wording supplies no numerical class. State the mesh design and forming requirements for evaluation; neither a finished mesh strength nor suitability for every exposure condition is established by this listing.
